Hi, this is Dinga. I’m going to repainting Dearbell’s Noel that I showed you last time. I decorated the doll with a cute, lovely Cupid angel. Well, let’s get started. Before I made a wig, I wrapped it around my doll and protected it. And I put a pre-made wig cap in the center of it. Today, I’m going to use this short baby pink hair. Like I showed you in the last video, I’m trying to make a short cut-style wig. It’s already too short for the wig, so I figured if I could figure out the location and attach it, I wouldn’t have to cut it separately later. So this time, I didn’t stick closely from the bottom like when I made a long hair wig. When it was finished, it was attached from the middle considering the length. First, put the doll’s bangs in a position that covers her eyebrows. And then, from the next time, I put it in a circle all the way to the top of my head. And roll a small amount of hair like on the screen and prepare it. carefully peeling off the wig I’ll drill a hole in the middle of it. Put the prepared hair in there and stick it on. And like the screen, I used a mini iron to press the raised hair calmly. So the short cut type wig is complete. I’m going to use the light purple eye I’ve made before. Now, for makeup, apply a matte coating on the doll’s face and dry it well. First of all, I drew the eyeliner in dark brown. It’s a thin, sleek end along the shape of the doll’s eyes. Smoothly blending eyeline with pastel, pink base on the doll’s eyes, I drew a double eyelid, a thin double eyelid that starts from the inside. And the doll’s eyebrows are mixed with pink and brown colors, and the shape of the eye drops down a bit first. I used colored pencils to express the doll’s eyebrows in detail. I shaded her along the front of her eyebrows and the noseline. And I’ll apply eye shadow. At the bottom of the eye, put the shade in bright pitch. I used pink on the front and tail of the doll’s eyes to make it look like a peach. And the doll’s cheeks are spread out with a bright pink pastel. Lightly wipe the tip of nose and forehead with the remaining amount of brush. I’ll draw the soft double eyelids one more time. Draw the eyelashes below. And paint the doll’s eyebrows with pink pastels to blend in with the hair color. The lips are painted thickly with red pastels inside, and then shaded. I’ve added a light pink pastel to her lips several times, I made the doll’s lips with such a thick and soft feel. And then use a coating spray to fix the makeup, I put on eyelashes like this. It’s just a glimmer of transparent enamel on the underside of the eye. I finished make-up by applying a shimmer on the doll’s nose and lips. Now, I made a costume using this feather fabric. I cut it around the waist of the doll and put a button on it. Put it on the doll like on the screen, mark the race with a pin in the center.
I used a glue gun to attach it to it. And I’m gonna put it back on the doll, and then I’m just gonna tie the back up like this. And the front part, like the screen, is wrinkled and sewn. It’s decorated with little feathers. The connection between the top and bottom of the costume was naturally covered with feathers. I put pearls on the chest of the costume. I’m going to make wings. First, I cut the formax long like this, and I made a frame of wings. I cut it into four like a screen, drill a hole in the overlap. Put a pin in there and glue it in. I cut off the rest of the pin with a nipper. I connected it like this and made it into an M-shaped shape. Put the feather fabric together in a large shape. I’ll add the feathers one by one so I can’t see the glue.
I’ve completed the wings of an angel. Put a small magnet in the middle of the wing. The doll’s back was also attached with magnets of the same shape so that it could be winged and detached. I’m going to try to make shoes. Draw with the doll’s feet on a thick piece of paper.
It creates a foot-shaped pattern. I made the soles of the shoes first, using white polymer-clay. Put a foot pattern on the clay and cut it with a knife. I baked it in the oven to make it hard. Sanding the rough spots, trim them smooth. I’ve been curled up with colored gel with pearl. And attach a wire as thin as a screen to the bottom of the shoe. Put it on the doll’s feet and wind it up like sandals. I made it look like this. I wanted to express it as if the vines were wrapped. So I decided to put these artificial plants on the wire one by one. I’ve made both of them. I put on top gel and glitters to make it shiny. And in the same way, I made a doll’s headdress. Wrap the wire round, cut it in the middle, and make it look like a screen. I’m gonna stick the artificial plant I used to make it look like a wreath. And I put glitters on this and finished it like this. Now I’m gonna make a bow and arrow that reminds me of when I do Cupid. First, I pushed the gold-colored polymer clay into thin and long pieces to make three. I twisted it like a screen to form a bow. I rolled up both ends to shape them. I wanted it to feel a little bit more metal, so I applied metal glitters and baked it in the oven. The bow was completed by tying a transparent fishing line to the bow. I’m gonna make an arrow out of this thin wooden stick. I’ll paint the sticks all gold. Put Uv resin in a heart-shaped mold and harden it to make two. I made a heart-shaped arrowhead by attaching it like this way. It’s decorated with artificial plants. Now let’s put what I’ve made on the doll. That’s the end of the video today. Thank you so much for watching the video today. Then let’s meet again in the next video. bye